Injection Molding
7 visualizaciones
TPE Overmolding Thickness Design
Fenómeno del problema
TPE overmolding layer too thin gives low bonding strength, too thick causes shrinkage and bubbles, with poor feel
Análisis de la causa
TPE overmolding layer thickness of 1.5-3.0mm gives the best bonding effect; too thin makes injection difficult with low bonding strength and poor feel; too thick is costly and prone to shrinkage and bubbles
Solución
①Design the overmolding layer thickness at 1.5-3.0mm; ②Uniform wall thickness; ③Gradual thick-to-thin transitions; after adjustment, continuously sample to verify the effect, and resume mass production only after confirming stability
Conclusión clave
TPE overmolding thickness has a clear window; 1.5-3.0mm is the best balance of bonding, feel, and cost; after confirming effectiveness, solidify the parameters and practices into the work instruction to prevent recurrence
¿Le ha resultado útil?
0 personas encontraron esto útil
¡Gracias por sus comentarios!