Injection Molding
2 visualizaciones
Premature Gate Freezing in PU '2079851475616104452
Fenómeno del problema
PU injection molded product gate freezes within 0.5-1s in the holding stage, holding pressure cannot be transmitted, product sink marks severe
Análisis de la causa
Gate size too small, diameter <1mm, causing rapid freezing; injection temperature too low; mold temperature too low accelerating gate cooling
Solución
1) Increase gate diameter to 1.5-2mm; 2) Increase injection temperature to 60-120°C; 3) Increase mold temperature to 40-50°C to delay gate freezing; 4) Holding pressure stepwise decay rather than sudden release
Conclusión clave
Premature gate freezing is caused by small gate and low temperature; enlarging the gate and increasing temperature are the fundamental measures
¿Le ha resultado útil?
0 personas encontraron esto útil
¡Gracias por sus comentarios!