Extrusion & Post
11 조회수
TPE Delamination (Excessive Release Agent)
문제 현상
Layered peeling appears on products after using release agent.
원인 분석
Excessive release agent sprayed on the cavity surface forms an isolation film, hindering interlayer bonding of the melt.; during on-site troubleshooting, verify item by item according to this mechanism, avoiding blind machine adjustment based solely on experience
해결 방법
①Control the release agent dosage; ②spray a uniform thin layer; ③prioritize process improvement for demolding; ④clean cavity residue.; after adjustment, continuously sample to verify the effect, and resume mass production only after confirming stability
핵심 요약
Excessive release agent is a hidden cause of delamination; do not use it if possible, and control the amount if used.; after confirming effectiveness, fix the parameters and practices into the work instruction to prevent recurrence
이 정보가 도움이 되었나요?
0 명이 도움이 되었다고 합니다
의견 주셔서 감사합니다!