Extrusion & Post
12 görüntüleme
TPE Delamination (Excessive Release Agent)
Sorun Belirtisi
Layered peeling appears on products after using release agent.
Neden Analizi
Excessive release agent sprayed on the cavity surface forms an isolation film, hindering interlayer bonding of the melt.; during on-site troubleshooting, verify item by item according to this mechanism, avoiding blind machine adjustment based solely on experience
Çözüm
①Control the release agent dosage; ②spray a uniform thin layer; ③prioritize process improvement for demolding; ④clean cavity residue.; after adjustment, continuously sample to verify the effect, and resume mass production only after confirming stability
Temel Çıkarım
Excessive release agent is a hidden cause of delamination; do not use it if possible, and control the amount if used.; after confirming effectiveness, fix the parameters and practices into the work instruction to prevent recurrence
Bu faydalı oldu mu?
0 kişi bunu faydalı buldu
Geri bildiriminiz için teşekkürler!