Injection Molding
5 조회수
EMA Injection Gate Freezes Too Early
문제 현상
The gate of EMA injection molded products freezes within 0.5-1s during the holding stage, holding pressure cannot be transmitted, product shrinkage severe
원인 분석
Gate size too small, diameter <1mm, causing rapid freezing; injection temperature low; mold temperature low, accelerating gate cooling
해결 방법
1) Increase gate diameter to 1.5-2mm; 2) Increase injection temperature to 160-210°C; 3) Increase mold temperature to 40-50°C to delay gate freezing; 4) Holding pressure decays in steps rather than sudden release
핵심 요약
Premature gate freezing is caused by small gate and low temperature; enlarging the gate and increasing temperature are fundamental measures
이 정보가 도움이 되었나요?
0 명이 도움이 되었다고 합니다
의견 주셔서 감사합니다!