Molds & Tooling
4 조회수
Wall thickness >5mm thick-walled products have prominent sink marks and bubble problems
문제 현상
Wall thickness >5mm thick-walled products have prominent sink marks and bubble problems
원인 분석
Thick walls have long cooling time, internal cooling slow, outer layer solidifies first, internal shrinkage sink marks
Holding pressure time insufficient, thick wall center not compacted
Gate too small, holding pressure cannot be transmitted to the thick wall center
Bubbles and voids inside thick walls
Cellulose acetate butyrate shrinkage rate 0.4-0.6%, thick wall shrinkage more obvious
해결 방법
Extend holding pressure time to ensure thick walls are fully compensated for shrinkage
Increase gate size, extend gate freezing time
Lower the mold temperature to accelerate outer layer cooling of thick walls
Extend overall cooling time
Avoid excessively thick wall thickness in design
핵심 요약
Thick walls require extended holding pressure and cooling time
이 정보가 도움이 되었나요?
0 명이 도움이 되었다고 합니다
의견 주셔서 감사합니다!