Injection Molding
3 조회수
DSTDP injection gate freezing too early
문제 현상
DSTDP injection molded product gate freezes within 0.5-1s during the holding stage, holding pressure cannot be transmitted, product sinks severely
원인 분석
Gate size too small, diameter <1mm causing fast freezing; injection temperature on the low side; mold temperature on the low side accelerating gate cooling
해결 방법
1) Increase gate diameter to 1.5-2mm; 2) raise injection temperature to 160-200°C; 3) raise mold temperature to 40-50°C to delay gate freezing; 4) holding pressure stepwise decay rather than sudden release
핵심 요약
Premature gate freezing is caused by small gate and low temperature; enlarging the gate and raising temperature are the fundamental measures
이 정보가 도움이 되었나요?
0 명이 도움이 되었다고 합니다
의견 주셔서 감사합니다!