Injection Molding
6 visualizações
DSTDP injection gate freezing too early
Fenómeno do problema
DSTDP injection molded product gate freezes within 0.5-1s during the holding stage, holding pressure cannot be transmitted, product sinks severely
Análise das causas
Gate size too small, diameter <1mm causing fast freezing; injection temperature on the low side; mold temperature on the low side accelerating gate cooling
Solução
1) Increase gate diameter to 1.5-2mm; 2) raise injection temperature to 160-200°C; 3) raise mold temperature to 40-50°C to delay gate freezing; 4) holding pressure stepwise decay rather than sudden release
Conclusão principal
Premature gate freezing is caused by small gate and low temperature; enlarging the gate and raising temperature are the fundamental measures
Isto foi útil?
0 pessoas acharam isto útil
Obrigado pelo seu comentário!