문제 및 해결책

일반적인 플라스틱 재료 문제에 대한 실질적인 답변

기사 둘러보기 →

Q

Post-shrinkage and dimensional drift of PP products

A

The core of PP dimension management is 'the post-aging dimension prevails': first unify the measurement time point, then use mold temperature and cooling to 'lock' crystallization in the mold as much as possible, and finally correct the mold with measured shrinkage; otherwise you will forever be ...

Molds & Tooling PP; post-shrinkage; post-crystallization; dimensional drift; aging; annealing

Q

Sink marks (shrinkage) on PP injection molded products

A

PP sink marks must be tackled with both 'structure + holding pressure': structurally reduce material and control rib thickness first, and in the process do enough holding pressure feeding and gate freeze-off management; only slamming on holding pressure at the machine without touching the structu...

Injection Molding PP; sink mark; shrinkage; holding pressure; rib thickness; gate freeze-off

Q

Warpage deformation of PP injection molded products

A

The essence of PP warpage is differential shrinkage; the treatment priority is: first balance the mold temperature field, then optimize holding pressure and cooling, and only finally consider structure and gate adjustments; never rely only on raising the mold temperature or only adding cooling—ap...

Injection Molding PP; warpage; shrinkage rate; mold temperature; crystallization; differential shrinkage

Q

PP Injection Part Sink Mark—Freeze-off Type

A

Holding after freeze-off = ineffective feeding—the gate is the key.

Injection Molding PP;sink mark;gate freeze-off;holding pressure;thick wall

Q

PP Part Low-temperature Drop Fracture

A

For PP low-temperature drop fracture, first modify the structure (fillets, reinforcing ribs, weld line avoidance), then change the grade (impact copolymer); passing at room temperature does not mean passing at low temperature—verification must simulate real use temperature.

Material Analysis PP;low temperature;drop;copolymer;fillet;grade

Q

PP Injection Part Metering Fluctuation

A

For unstable plasticization, check feeding first.

Injection Molding PP;plasticization fluctuation;bridging;pulverized material;feeding

Q

PP Injection Part Deformation—Packaging-Induced

A

Packing hot parts = secondary deformation source.

Injection Molding PP;deformation;packaging;creep;stacking

Q

PP Sheet Die Lip Buildup

A

PP die lip buildup is an accumulation process of 'stagnation degradation': cleaning treats the symptom, while temperature-speed matching treats the root; the interval pattern of periodic streaks from buildup can back-calculate the buildup shedding cycle.

Extrusion & Post PP;extrusion;die lip buildup;mold deposit;stagnation;streak

Q

PP Injection Part Gloss Deficiency

A

Gloss = replication + mold + grade, three elements.

Injection Molding PP;gloss;replication;polishing;mold temperature

Q

PP Nozzle Drooling

A

PP's low viscosity makes drooling easy—'lower nozzle temperature + add suck-back' is the first-choice combination; if ineffective, replace the nozzle or use a valve gate; cold slug marks from drooling spread to the next shot—stop it at the source.

Molds & Tooling PP;drooling;nozzle;suck-back;valve gate

이전 1 ... 708 709 710 711 712 713 714 ... 1164 다음

카테고리

전체 주제 11636 Material Drying 1439 Injection Molding 1506 Molding Process 740 Molds & Tooling 1506 Processing Machinery 2025 Extrusion & Post 2239 Blow Molding 315 Thermoforming 141 Material Analysis 1343 Production & Quality 382