Extrusion & Post
8 views
Dense EAA surface pits
Problem Phenomenon
Dense pits of 0.1-0.3mm on the EAA product surface affecting appearance and coating adhesion
Cause Analysis
Raw material contains impurity particles >0.05%; mold cavity surface damaged or corroded with pits
Solution
1) Replace with pure raw material with impurities <0.01%; 2) Repair and polish the mold cavity to Ra<0.2μm; 3) Filter the raw material to remove particles
Key Takeaway
Pits are caused by raw material impurities and mold damage; pure raw material and mold maintenance are the key
Was this helpful?
0 people found this helpful
Thank you for your feedback!