Extrusion & Post
8 views
Dense Surface Pits of CMC
Problem Phenomenon
Dense pits of 0.1-0.3mm on the surface of CMC products affect appearance and coating adhesion
Cause Analysis
Raw material contains impurity particles >0.05%; mold cavity surface is damaged or has corrosion pits
Solution
1)Replace with pure raw material with impurities <0.01%; 2)Repair and polish mold cavity to Ra<0.2μm; 3)Filter raw material to remove particles
Key Takeaway
Pits are caused by raw material impurities and mold damage; pure raw material and mold maintenance are the key
Was this helpful?
0 people found this helpful
Thank you for your feedback!