Processing Machinery
8 views
Screw wear of polyolefin plastomer extruders causes poor plasticization
Problem Phenomenon
Unmelted particles appear in the product, the surface is rough, and the plasticization quality declines.
Screw wear weakens the shearing and mixing effects, and the melt quality is unstable.
Cause Analysis
（1）The screw wears after long-term use, and the gap between the flight and the barrel increases
（2）The raw material contains hard fillers that accelerate wear
（3）The wear resistance of the screw material is insufficient
（4）The screw speed is too high, aggravating wear
（5）The barrel temperature is set improperly, causing local overload
Solution
（1）Check the screw wear; repair or replace it if the gap exceeds 0.2mm
（2）Select wear-resistant screw materials or bimetallic screws
（3）Reduce the screw speed for raw materials containing fillers
（4）Optimize the barrel temperature settings to ensure each section is at a reasonable value within the range of 180-230°C
（5）Regularly maintain the screw and clean the attachments on the screw surface
Key Takeaway
Screw wear causes the plasticization efficiency to decline, and needs to be solved by selecting wear-resistant materials and regular maintenance.
Was this helpful?
0 people found this helpful
Thank you for your feedback!