Problem & Solution

Practical answers to common plastic material challenges

Browse Articles →

PETG poor compatibility with inks and coatings, undercutting

PETG coating requires attention to solvent system selection.

Extrusion & Post PETGcoatingundercuttingsolvent erosion

PETG sheet orange peel texture during vacuum forming

PETG orange peel texture is a manifestation of surface overheating or mold roughness.

Thermoforming PETGorange peel textureheating temperaturemold roughness

PETG UV-curable coating insufficient adhesion

PETG UV coating adhesion depends on surface treatment and formulation optimization.

Extrusion & Post PETGUV coatingadhesioncorona

PETG injection molded product cold slug spots

PETG cold slug spots are a manifestation of cold slug mixing in.

Injection Molding PETGcold slug spotnozzle temperaturecold slug well

PETG copolyester insufficient oil resistance

Molding Process PETGoil resistanceswellingstress cracking

PETG extruded pipe surface corrugation

Extrusion & Post PETGpipesurface corrugationmelt fracturehaul-off

PETG product hygienic performance substandard

Material Analysis PETGfood contactmigrantsFDA

PETG injection molded product sticking at the hot runner gate

PETG hot runner gate sticking requires investigation from temperature and mechanics.

Injection Molding PETGhot runnergate stickingvalve pin

PETG recycled pelletizing pellet yellowing

Extrusion & Post PETGrecyclingpelletizingyellowingthermal history

PETG regrind performance degradation

PETG reuse requires controlling the ratio and performing stabilization treatment.

Material Drying PETGregrindperformance degradationdegradationstabilizer

Prev 1 ... 65 66 67 68 69 70 71 ... 1164 Next