Release agent oil stains appearing on the product surface

During the injection '2079851475616104457 production process, the product exhibits the quality defect of "Release agent oil stains appearing on the product surface". Specifically manifested as oil stain marks on the product surface. This defect is relatively common when processing materials such as PET, PP, HDPE, and PS, and its occurrence conditions are usually related to unreasonable settings of injection pressure, parison temperature, blowing air pressure, and mold temperature. When the Release agent oil stains appearing on the product surface situation is severe, it will cause a series of chain-reaction quality defects in the product in terms of appearance, dimensional accuracy, mechanical properties, etc., which not only reduces the usability and safety of the product, but also directly increases the scrap rate and production cost. Therefore, this problem requires systematic diagnosis and optimization from multiple dimensions, including material selection, the condition of the injection '2079851475616104457 machine, core rod, parison mold, blow mold, and transfer mechanism, as well as injection pressure, parison temperature, blowing air pressure, and mold temperature.

1. Release agent sprayed too much or concentration too high. This factor leading to the problem reflects that certain process conditions or material properties in injection blow '2079851475616104453ing have not met the optimal molding requirements. Such problems often have cumulative and hidden characteristics, and should be investigated and verified as key focus items during process debugging and finalization to ensure that hidden dangers are eliminated from the source. In addition, insufficient overall coordination between parison wall thickness uniformity and transfer temperature control is also a factor that cannot be ignored; there are complex interactions and coupling relationships among the various process parameters, and the deviation of any single parameter may aggravate the degree of Release agent oil stains appearing on the product surface through chain effects.

1. Reduce the amount of release agent. Adjustments should follow the principle of gradual progress; the magnitude of each adjustment should not be too large, and it is recommended to decrease in steps of 5%~15% of the current value. After each adjustment, observe the product quality changes stably for at least 5~10 mold cycles, and continue adjusting only after confirming that the improvement direction is correct; one-step excessive adjustment must be avoided. 2. Use a low-concentration release agent. Before introducing new tools, new materials, or new methods, a full applicability assessment and small-batch verification should be carried out. It is recommended to first conduct offline tests or simulation analysis outside of production conditions, and introduce them into the formal production line only after confirming effectiveness and safety. Keep change management records to facilitate subsequent traceability and experience accumulation. 3. Switch to a silicone-based release agent. Before implementing this measure, its feasibility and expected effect should be fully evaluated, and the details of the plan should be communicated and confirmed with relevant technical personnel; during implementation, changes in key quality indicators should be closely monitored, and the adjustment effect should be recorded and fed back in a timely manner to form reusable process experience. In terms of material management, incoming inspection of raw materials and in-process inspection of work-in-progress should be strengthened, and the key performance indicators of PET, PP, HDPE, and PS should be strictly controlled to ensure the stability of molding quality from the source.

In summary, the causes of the "Release agent oil stains appearing on the product surface" problem can be attributed to the combined action of multiple factors such as release agent sprayed too much or concentration too high. Solving this problem requires starting from aspects such as reduce the amount of release agent and use a low-concentration release agent, and adopting systematic governance measures. In actual production, it is recommended to establish a prevention and rapid response mechanism for this problem, achieving stable production and continuous improvement through parison wall thickness uniformity and transfer temperature control.