Processing Machinery
7 visualizações
ASA screw speed medium
Fenómeno do problema
[Problem phenomenon] ASA screw speed too high causes excessive plasticization shear, too low causes insufficient feeding
Análise das causas
ASA recommends medium screw speed: high speed shear heat and glass fiber grade fiber breakage risk, low speed slow plasticization; medium speed with external heat plasticization is most stable; during on-site investigation, verify item by item according to this mechanism, avoid blindly adjusting the machine based on experience alone
Solução
Screw speed set at medium speed; glass fiber grades lower to preserve fibers; plasticization fluctuations check heater bands and compression ratio; after adjustment, continuously sample to verify the effect, and resume mass production after confirming stability
Conclusão principal
ASA screw medium speed is the norm, external heat primary shear secondary; after confirming effectiveness, solidify the parameters and practices into the work instruction to prevent recurrence; include this case in the defect archive as a troubleshooting reference for subsequent similar problems
Isto foi útil?
0 pessoas acharam isto útil
Obrigado pelo seu comentário!