Injection Molding
2 visualizações
PEEK Flash
Fenómeno do problema
Flake-like flash appears at the parting line, ejector pin holes, and slide fits of PEEK products; the flash of glass fiber reinforced grades is hard and brittle and difficult to remove, and trimming easily damages the product.
Análise das causas
PEEK has high injection pressure, and the melt is squeezed in when the clamping force is insufficient or gaps appear due to wear of the mold parting line; the mold works long-term at high temperature, and platen deformation and fit wear accelerate gap formation.
Solução
①Check and increase the clamping force, calculated by projected area and cavity pressure; ②Overhaul the parting line to restore fitting precision; ③Appropriately reduce injection pressure and holding pressure; ④Check the thermal expansion fit of the mold at high temperature.
Conclusão principal
PEEK's high injection pressure places higher demands on clamping and mold rigidity; recurring flash mostly stems from mold wear rather than parameters; the mold maintenance cycle for high-temperature working conditions should be shortened.
Isto foi útil?
0 pessoas acharam isto útil
Obrigado pelo seu comentário!