Injection Molding
7 visualizações
PPO Holding Pressure Ratio
Fenómeno do problema
【Problem Phenomenon】PPO holding pressure is set improperly, and sink mark and internal stress problems alternate
Análise das causas
PPO holding pressure is generally 40%-60% of injection pressure; too low means insufficient feeding and sink marks, too high means internal stress and demolding difficulty; during on-site troubleshooting, verify item by item according to this mechanism, and avoid blindly adjusting the machine based solely on experience
Solução
Set holding pressure at 40-60% of injection pressure; sink mark parts take the upper limit, stress-sensitive parts take the lower limit; holding pressure time is determined by gate freezing; after adjustment, continuously sample to verify the effect, and resume mass production after confirming stability
Conclusão principal
PPO holding pressure is 40-60% of injection pressure; take the value by weighing sink marks versus stress; after confirming effectiveness, fix the parameters and practices into the work instruction to prevent recurrence
Isto foi útil?
0 pessoas acharam isto útil
Obrigado pelo seu comentário!