Extrusion & Post
13 visualizações
Out-of-tolerance ovality of EAA extruded pipe
Fenómeno do problema
The ovality of EAA extruded pipe is >1.05, exceeding the 1.02 standard requirement
Análise das causas
Uneven pipe cooling, one-sided cooling; unreasonable sizing sleeve design; uneven haul-off clamping force causes the pipe to deform under pressure
Solução
1) Use annular spray cooling to ensure uniform cooling; 2) Optimize the inner diameter and taper design of the sizing sleeve; 3) Multi-caterpillar uniform clamping haul-off; 4) Increase the length of the vacuum sizing section to ensure full sizing
Conclusão principal
Ovality is caused by uneven cooling and clamping; annular cooling and uniform haul-off are the key
Isto foi útil?
0 pessoas acharam isto útil
Obrigado pelo seu comentário!