Extrusion & Post
11 visualizações
Connected pellets in EVA extrusion pelletizing
Fenómeno do problema
During EVA extrusion pelletizing, pellets are connected and not fully cut, forming bead strings
Análise das causas
EVA is soft; during pelletizing the knife cuts in but elastic recovery makes cut surfaces re-adhere; pelletizing water temperature too low <40°C without full solidification; cutter speed not matching extrusion speed
Solução
1) Increase pelletizing water temperature to 50-60°C to cut after full solidification; 2) Increase cutter speed to ensure fast cutting; 3) Cutter gap 0.01-0.02mm to ensure clean cutting; 4) Rotary cutter replacing flat cutter to reduce connected pellets
Conclusão principal
Connected pellets are caused by elastic recovery and low temperature pelletizing; high temperature water cutting and fast cutting are key
Isto foi útil?
0 pessoas acharam isto útil
Obrigado pelo seu comentário!