Injection Molding
1 visualizações
Product has short shots, flash, or unstable dimensions
Fenómeno do problema
The product has short shots, flash, or unstable dimensions, related to the injection pressure setting
Análise das causas
Injection pressure too high, producing flash and internal stress
Injection pressure too low, causing material shortage and short shot
Holding pressure set improperly, affecting dimensions and shrinkage
Pressure switchover point set unreasonably
Hydraulic system unstable, pressure fluctuation
Solução
Reasonably set injection pressure according to cellulose acetate butyrate characteristics
Holding pressure is usually 60-80% of injection pressure
Optimize the pressure switchover point (V-P switchover)
Check hydraulic system stability
Avoid excessive pressure producing flash
Conclusão principal
Injection pressure needs to be reasonably set according to material and product
Isto foi útil?
0 pessoas acharam isto útil
Obrigado pelo seu comentário!