Extrusion & Post
15 visualizações
Random copolymer polypropylene pipe special material (Nordic standard） extrusion process unstable output/surging（Variant: Strengthened Measures）
Fenómeno do problema
The extruder output is sometimes more and sometimes less, the extrudate is uneven in thickness, and periodic surging occurs.
Unstable output directly affects product dimensional accuracy and quality consistency.In particular, extra attention is needed on top of the original basis, this problem is more prominent and requires key attention.
Análise das causas
（1）The screw feed section conveys unstably, the solid bed breaks\
（2）The hopper discharges poorly, the raw material bridges\
（3）Barrel temperature set improperly, feed section temperature too high or too low\
（4）Screw speed fluctuates\
（5）Raw material particle size uneven or contains too much powder\
（6）On top of the original basis, extra attention is needed: process parameter fluctuations or equipment status changes aggravate this problem
Solução
（1）Optimize the barrel temperature distribution, appropriately lower the feed section temperature to prevent premature melting\
（2）Install a vibrator on the hopper to prevent bridging and ensure continuous discharge\
（3）Reasonably set the temperature of each barrel section, ensure it is within the 200-220°C range\
（4）Check the extruder drive system, stabilize the screw speed\
（5）Control raw material particle uniformity, powder proportion not exceeding 5%\
（6）And strengthen process monitoring; on top of the original basis, extra attention is needed, paying special attention to parameter stability
Conclusão principal
Unstable output is caused by unstable solids conveying, requiring optimization of barrel temperature and the feeding system.Targeted preventive measures need to be taken in different production scenarios.
Isto foi útil?
0 pessoas acharam isto útil
Obrigado pelo seu comentário!