Molds & Tooling
6 visualizações
Obvious Gate Marks on PCTG Products
Fenómeno do problema
Raised or depressed marks are left at the gate break point.
Análise das causas
The gate design is improper (the submarine gate angle is large or the side gate is too thick), and the breakage during demolding is not ideal.
Solução
Optimize the gate design (needle valve gate or pin-point gate); adjust the demolding sequence and speed.
Conclusão principal
PCTG gate marks are an appearance quality control point.
Isto foi útil?
0 pessoas acharam isto útil
Obrigado pelo seu comentário!