Injection Molding
7 visualizações
PETG '2079851475616104452 insufficient melt cushion
Fenómeno do problema
The melt cushion at the front of the screw is insufficient, and the holding pressure effect is poor.
Análise das causas
Metering stroke set too short, back pressure insufficient and melt not dense enough, check ring leakage.
Solução
Increase the metering stroke to ensure a sufficient cushion of 3-6mm; appropriately increase back pressure; check the check ring.
Conclusão principal
PETG melt cushion is the basis of holding pressure effectiveness.
Isto foi útil?
0 pessoas acharam isto útil
Obrigado pelo seu comentário!