Problema e solução

Q

Insects or foreign matter trapped between layers

A

This problem requires comprehensive analysis from multiple dimensions of materials, processes, equipment, and operation, and should be solved by systematically optimizing process parameters and the quality control system.

Extrusion & Post layup insects or foreign matter trapped between layers process optimization

Q

Resin sagging before gelation in FRP hand lay-up laminated products

A

This problem requires comprehensive analysis from multiple dimensions of materials, processes, equipment, and operation, and should be solved by systematically optimizing process parameters and the quality control system.

Extrusion & Post layup resin content FRP gelation

Q

Uneven heating of hot-melt film in thermoplastic lamination (composite boards)

A

This problem requires comprehensive analysis from multiple dimensions of materials, processes, equipment, and operation, and should be solved by systematically optimizing process parameters and the quality control system.

Extrusion & Post hot pressing thermoplastic lamination composite board uneven heating of hot-melt film

Q

Laminate "drilling-out/punching delamination"

A

The essence of interlayer separation problems is insufficient interface bonding force, requiring systematic improvement from three aspects: impregnation quality, interlayer cleanliness, and process parameters.

Extrusion & Post laminate drilling-out punching delamination

Q

Low peel strength between copper foil and substrate

A

The core cause of insufficient mechanical properties is inadequate material bonding or degradation; the sintering/curing process needs to be optimized and raw material quality controlled.

Extrusion & Post low peel strength between copper foil and substrate process optimization

Q

Decreased electrical insulation strength of laminated products

A

The core cause of insufficient mechanical properties is inadequate material bonding or degradation; the sintering/curing process needs to be optimized and raw material quality controlled.

Extrusion & Post resin content vacuum assistance fiber

Q

Glass fiber reinforced laminate shows "glass pattern"

A

This problem requires comprehensive analysis from multiple dimensions of materials, processes, equipment, and operation, and should be solved by systematically optimizing process parameters and the quality control system.

Extrusion & Post resin content fiber glass fiber reinforced laminate shows glass pattern

Q

Separator film trapped in prepreg layup

A

This problem requires comprehensive analysis from multiple dimensions of materials, processes, equipment, and operation, and should be solved by systematically optimizing process parameters and the quality control system.

Extrusion & Post layup prepreg separator film trapped in prepreg layup

Q

Prepreg stored too long losing tack

A

This problem requires comprehensive analysis from multiple dimensions of materials, processes, equipment, and operation, and should be solved by systematically optimizing process parameters and the quality control system.

Extrusion & Post prepreg prepreg stored too long losing tack process optimization

Q

Impregnation tank liquid level fluctuation on continuous lamination production line

A

This problem requires comprehensive analysis from multiple dimensions of materials, processes, equipment, and operation, and should be solved by systematically optimizing process parameters and the quality control system.

Extrusion & Post impregnation impregnation tank liquid level fluctuation on continuous lamination production line process optimization

Problema e solução

Categorias

Pedir orçamento