Extrusion & Post
5 görüntüleme
EVA Film High Shrinkage Rate
Sorun Belirtisi
Film shrinkage after lamination causes cell displacement or microcracks.
Neden Analizi
The film itself has a high shrinkage rate or the lamination process does not match; differences in shrinkage characteristics of different batches of film also cause fluctuations.; During on-site troubleshooting, verify item by item according to this mechanism to avoid blindly adjusting the machine based only on experience
Çözüm
①Select a low-shrinkage film; ②optimize the lamination temperature curve; ③test the shrinkage rate of incoming materials by batch; ④fine-tune the lamination process with the batch.; After adjustment, continuously sample to verify the effect, and resume mass production after confirming stability
Temel Çıkarım
Film shrinkage affects module reliability; low-shrinkage material plus process matching is the solution.; After confirming effectiveness, fix the parameters and practices into the work instruction to prevent recurrence
Bu faydalı oldu mu?
0 kişi bunu faydalı buldu
Geri bildiriminiz için teşekkürler!