Molds & Tooling
4 görüntüleme
PC Gas Trapping and Burning
Sorun Belirtisi
Black spots and scorch marks appear at the end of the PC product cavity, possibly accompanied by a burnt smell, at fixed positions.
Neden Analizi
When venting is poor, compressed air adiabatically heats up and burns the plastic; PC's high processing temperature makes the diesel effect more likely to occur; high-speed filling at the end and blocked vent slots both induce it.
Çözüm
①Open/clean vent slots; ②Reduce injection speed at the end; ③Do not over-apply clamping force to avoid closing the vents; ④Check insert fitting clearances; ⑤Reduce release agent contamination of the vents.
Temel Çıkarım
PC 'high-temperature material fears gas trapping more': venting is a life-saving design; the higher the processing temperature, the greater the risk of gas-trapping burning, and the design and maintenance of the venting system must be in place; after confirming effectiveness, solidify the parameters and practices into the work instruction to prevent recurrence.
Bu faydalı oldu mu?
0 kişi bunu faydalı buldu
Geri bildiriminiz için teşekkürler!