Extrusion & Post
12 görüntüleme
PVB Edge-Center Composite Bubbles
Sorun Belirtisi
Bubbles appear simultaneously at the edge and center of laminated glass, more common in non-matched tempered laminated glass.
Neden Analizi
Poor glass flatness matching; thin PVB film; slow roller pressing sealing too early; poor roller pressing performance; excessive edge mechanical pressure; residual stress exceeding limits.; When troubleshooting on site, verify item by item according to this mechanism, avoiding blind machine adjustment based only on experience
Çözüm
①Glass flatness matching inspection; ②Sufficient PVB thickness; ③Roller pressing process optimization; ④Mechanical pressure control; ⑤Stress management.; After adjustment, continuously sample to verify the effect, confirm stability before resuming mass production
Temel Çıkarım
Glass matching is the primary factor for PVB composite bubbles; roller pressing process finely adjusted; stress management runs throughout.; After confirming effectiveness, fix the parameters and practices into the work instruction to prevent recurrence
Bu faydalı oldu mu?
0 kişi bunu faydalı buldu
Geri bildiriminiz için teşekkürler!