Extrusion & Post
13 مشاهدة
PVB Edge-Center Composite Bubbles
ظاهرة المشكلة
Bubbles appear simultaneously at the edge and center of laminated glass, more common in non-matched tempered laminated glass.
تحليل الأسباب
Poor glass flatness matching; thin PVB film; slow roller pressing sealing too early; poor roller pressing performance; excessive edge mechanical pressure; residual stress exceeding limits.; When troubleshooting on site, verify item by item according to this mechanism, avoiding blind machine adjustment based only on experience
الحل
①Glass flatness matching inspection; ②Sufficient PVB thickness; ③Roller pressing process optimization; ④Mechanical pressure control; ⑤Stress management.; After adjustment, continuously sample to verify the effect, confirm stability before resuming mass production
الخلاصة الأساسية
Glass matching is the primary factor for PVB composite bubbles; roller pressing process finely adjusted; stress management runs throughout.; After confirming effectiveness, fix the parameters and practices into the work instruction to prevent recurrence
هل كان هذا مفيدًا؟
0 شخص وجدوا هذا مفيدًا
شكرًا لك على ملاحظاتك!