Extrusion & Post
12 görüntüleme
EVA extruded film has gel particles
Sorun Belirtisi
Transparent gel particles of 0.1-0.5mm appear on the surface of EVA extruded film
Neden Analizi
High molecular weight components in EVA are not fully melted during extrusion, forming local highly crystalline regions; extrusion temperature too low or insufficient mixing
Çözüm
1) Increase extrusion temperature by 5-10°C to ensure full melting; 2) Increase the length of the screw mixing section; 3) Inspect raw material to ensure consistent grade; 4) Replace with a finer 120-mesh screen to intercept unmelted particles
Temel Çıkarım
Gel particles are caused by insufficient melting; increasing temperature and mixing are key
Bu faydalı oldu mu?
0 kişi bunu faydalı buldu
Geri bildiriminiz için teşekkürler!