Extrusion & Post
11 görüntüleme
Longitudinal stripes on PVA extruded film
Sorun Belirtisi
Continuous stripes 1-3mm wide along the extrusion direction on the surface of PVA extruded film
Neden Analizi
Local damage or uneven gap of die lips; melt residence zone in the die producing unstable flow; pressure fluctuation at the screw front end
Çözüm
1) Check die lip flatness and gap uniformity ±0.01mm; 2) Clean the die interior to remove carbonized matter in the residence zone; 3) Install gear pump on the extruder to stabilize melt pressure; 4) Polish die lips to Ra<0.1μm
Temel Çıkarım
Longitudinal stripes are caused by die defects and pressure fluctuation; die maintenance and pressure stability are key
Bu faydalı oldu mu?
0 kişi bunu faydalı buldu
Geri bildiriminiz için teşekkürler!