Extrusion & Post
11 görüntüleme
PVA screw slipping
Sorun Belirtisi
During PVA extrusion, the screw slips, feed does not advance, output drops sharply
Neden Analizi
PVA pellets melt too early in the feed section forming a lubricating film causing screw slip; feed section temperature too high
Çözüm
1) Lower feed section temperature by 10-15°C to delay melting; 2) Deepen the feed section flight to increase material gripping force; 3) Dry the pellet surface to reduce lubrication
Temel Çıkarım
Screw slipping is caused by premature melting; lowering the feed section temperature is the key
Bu faydalı oldu mu?
0 kişi bunu faydalı buldu
Geri bildiriminiz için teşekkürler!