Extrusion & Post
12 مشاهدة
PVA screw slipping
ظاهرة المشكلة
During PVA extrusion, the screw slips, feed does not advance, output drops sharply
تحليل الأسباب
PVA pellets melt too early in the feed section forming a lubricating film causing screw slip; feed section temperature too high
الحل
1) Lower feed section temperature by 10-15°C to delay melting; 2) Deepen the feed section flight to increase material gripping force; 3) Dry the pellet surface to reduce lubrication
الخلاصة الأساسية
Screw slipping is caused by premature melting; lowering the feed section temperature is the key
هل كان هذا مفيدًا؟
0 شخص وجدوا هذا مفيدًا
شكرًا لك على ملاحظاتك!