Extrusion & Post
11 görüntüleme
CEF extrusion film longitudinal streaks
Sorun Belirtisi
The surface of the CEF extruded film has continuous streaks along the extrusion direction, width 1-3mm
Neden Analizi
Local damage or uneven gap of the die lip; unstable flow generated in the melt residence area in the die; pressure fluctuation at the front end of the screw
Çözüm
1) Check the flatness of the die lip and the gap uniformity ±0.01mm; 2) Clean the inside of the die to remove carbides in the residence area; 3) Install a gear pump on the extruder to stabilize the melt pressure; 4) Polish the die lip to Ra<0.1μm
Temel Çıkarım
Longitudinal streaks are caused by die defects and pressure fluctuations; die maintenance and pressure stability are the key
Bu faydalı oldu mu?
0 kişi bunu faydalı buldu
Geri bildiriminiz için teşekkürler!