Extrusion & Post
13 visualizações
CEF extrusion film longitudinal streaks
Fenómeno do problema
The surface of the CEF extruded film has continuous streaks along the extrusion direction, width 1-3mm
Análise das causas
Local damage or uneven gap of the die lip; unstable flow generated in the melt residence area in the die; pressure fluctuation at the front end of the screw
Solução
1) Check the flatness of the die lip and the gap uniformity ±0.01mm; 2) Clean the inside of the die to remove carbides in the residence area; 3) Install a gear pump on the extruder to stabilize the melt pressure; 4) Polish the die lip to Ra<0.1μm
Conclusão principal
Longitudinal streaks are caused by die defects and pressure fluctuations; die maintenance and pressure stability are the key
Isto foi útil?
0 pessoas acharam isto útil
Obrigado pelo seu comentário!