Extrusion & Post
11 görüntüleme
MP extruded film longitudinal streaks
Sorun Belirtisi
MP extruded film surface has continuous streaks along the extrusion direction, width 1-3mm
Neden Analizi
die lip locally damaged or gap uneven; unstable flow from the melt stagnation zone inside the die; pressure fluctuation at the screw front end
Çözüm
1) check die lip flatness and gap uniformity ±0.01mm; 2) clean the die interior to remove carbonized material in stagnation zones; 3) install a gear pump on the extruder to stabilize melt pressure; 4) polish die lip to Ra<0.1μm
Temel Çıkarım
longitudinal streaks are caused by die defects and pressure fluctuation; die maintenance and pressure stability are key
Bu faydalı oldu mu?
0 kişi bunu faydalı buldu
Geri bildiriminiz için teşekkürler!