Injection Molding
8 مشاهدة
PA6 Flash
ظاهرة المشكلة
Thin-sheet flash at the parting line and ejector pins.
تحليل الأسباب
PA6 melt has low viscosity and easily penetrates into fitting clearances under high pressure; high injection pressure, insufficient clamping, and mold wear.
الحل
①Reduce injection/holding pressure;②calculate the clamping force;③repair the parting line and ejector pin clearances;④appropriately lower the material temperature to increase viscosity.
الخلاصة الأساسية
Low-viscosity nylon flash = a war between pressure and clearance.
هل كان هذا مفيدًا؟
0 شخص وجدوا هذا مفيدًا
شكرًا لك على ملاحظاتك!