Thermoforming
6 مشاهدة
PVC '2079851475616104458 Chill Marks
ظاهرة المشكلة
Cold lines and haze marks on product surface, corresponding to plug/mold surface contact areas.
تحليل الأسباب
Hot sheet contacts cold plug/mold surface prematurely and is quenched; mold temperature too low; set before stretching is completed, leaving stress marks; during on-site troubleshooting, verify item by item according to this mechanism, avoid blindly adjusting the machine based solely on experience.
الحل
①Heat the plug; ②Appropriately increase mold temperature to improve melt replication and fit to cavity surface; ③Slow down plug speed; ④Balance heating zones; ⑤Check direct airflow blowing.
الخلاصة الأساسية
PVC chill mark = 'touching cold surface prematurely': raising mold temperature and slowing contact can eliminate it; a typical temperature management problem, unrelated to the material itself; after confirming effectiveness, fix the parameters and practices into the work instruction to prevent recurrence.
هل كان هذا مفيدًا؟
0 شخص وجدوا هذا مفيدًا
شكرًا لك على ملاحظاتك!