Blow Molding
5 مشاهدة
PVC vs ABS/PP Comparison
ظاهرة المشكلة
PVC was chosen to replace ABS to save material cost, but the scrap rate stayed high and total cost rose instead
تحليل الأسباب
PVC raw material is 40-60% cheaper but difficult to process: scrap rate, anti-corrosion molds, and long cycles can increase total cost by 5-20%; when there is no chemical resistance or flame retardant requirement, PP/ABS is more economical
الحل
①Select material by application requirements rather than only raw material price; ②choose PVC for chemical corrosion resistance and flame retardant scenarios; ③choose ABS/PP for consumer electronics and appearance parts; after adjustment, continuously sample to verify the effect, and resume mass production after confirming stability
الخلاصة الأساسية
The cost of PVC must be calculated as a total; cheap material does not equal cheap parts, and process cost must be included; after confirming effectiveness, fix the parameters and practices into the work instruction to prevent recurrence
هل كان هذا مفيدًا؟
0 شخص وجدوا هذا مفيدًا
شكرًا لك على ملاحظاتك!