Extrusion & Post
13 مشاهدة
TPE extrusion deformation
ظاهرة المشكلة
TPE extruded products deform, cooling is uneven, and double-layer extrusion shrinks differently
تحليل الأسباب
Causes of TPE extrusion deformation: uneven cooling, double-layer extrusion with different shrinkage rates; slow curing speed, mismatched haul-off speed; during on-site troubleshooting, verify item by item according to this mechanism, and avoid blindly adjusting the machine based only on experience
الحل
①uniform cooling; ②adjust shrinkage rate matching; ③increase curing speed; after adjustment, continuously sample to verify the effect, and resume mass production only after confirming stability; change only one variable at a time and record parameter changes, so as to locate effective measures
الخلاصة الأساسية
TPE extrusion deformation is troubleshooted along the three lines of cooling, shrinkage, and curing; shrinkage matching of double-layer extrusion is a special consideration; after confirming effectiveness, fix the parameters and practices into the work instruction to prevent recurrence
هل كان هذا مفيدًا؟
0 شخص وجدوا هذا مفيدًا
شكرًا لك على ملاحظاتك!