Extrusion & Post
13 مشاهدة
EVA extrusion melt fracture
ظاهرة المشكلة
Severe melt fracture occurs when EVA extrusion rate is too high, with extrudate twisted in spiral shape
تحليل الأسباب
EVA melt elasticity too high with elastic recovery at die exit exceeding critical value; die L/D ratio too short <10 with melt not fully relaxed; extrusion temperature too low
الحل
1) Reduce extrusion rate to 2-3m/min; 2) Increase die L/D ratio to 15-20; 3) Increase extrusion temperature to 140-200°C; 4) Add small amount of low-elasticity resin to reduce system elasticity; 5) Progressive converging die entrance design
الخلاصة الأساسية
Melt fracture is caused by elastic recovery exceeding critical value; reducing speed and lengthening die are the core countermeasures
هل كان هذا مفيدًا؟
0 شخص وجدوا هذا مفيدًا
شكرًا لك على ملاحظاتك!