Injection Molding
7 مشاهدة
Burnt Marks from Insufficient Mold Venting in PU '2079851475616104452
ظاهرة المشكلة
PU injection mold venting insufficient, air in the cavity compressed and heated causing local burning
تحليل الأسباب
Mold vent groove area insufficient or position improper; injection speed too fast, air has no time to escape; air compressed to high temperature >200°C causing oxidative burning
الحل
1) Increase vent groove area, depth 0.02-0.03mm, width 5-10mm; 2) Set vent grooves at the last-fill areas of the melt; 3) Reduce injection speed to decrease air compression; 4) Multi-stage injection with slow advancement for venting
الخلاصة الأساسية
Burning is caused by insufficient venting and high-speed injection compressing air; increasing venting and reducing speed are key
هل كان هذا مفيدًا؟
0 شخص وجدوا هذا مفيدًا
شكرًا لك على ملاحظاتك!