Injection Molding
7 مشاهدة
Ejection Whitening on PU Injection Molded Products
ظاهرة المشكلة
White marks (ejection whitening) appear at ejector pin positions on PU injection molded products, affecting appearance
تحليل الأسباب
Ejector pin force too large causing local compression deformation whitening; cooling time insufficient, product ejected before fully cured; ejector pin area too small, stress concentration
الحل
1) Extend cooling time to fully cure the product before ejection; 2) Increase ejector pin area, use an ejector plate to replace small pins; 3) Reduce ejection speed to decrease impact force; 4) Increase draft angle to reduce ejection force
الخلاصة الأساسية
Ejection whitening is caused by excessive ejection force and insufficient cooling; increasing ejector pin area and extending cooling time are key
هل كان هذا مفيدًا؟
0 شخص وجدوا هذا مفيدًا
شكرًا لك على ملاحظاتك!