Injection Molding
2 visualizaciones
Ejection Whitening on PU Injection Molded Products
Fenómeno del problema
White marks (ejection whitening) appear at ejector pin positions on PU injection molded products, affecting appearance
Análisis de la causa
Ejector pin force too large causing local compression deformation whitening; cooling time insufficient, product ejected before fully cured; ejector pin area too small, stress concentration
Solución
1) Extend cooling time to fully cure the product before ejection; 2) Increase ejector pin area, use an ejector plate to replace small pins; 3) Reduce ejection speed to decrease impact force; 4) Increase draft angle to reduce ejection force
Conclusión clave
Ejection whitening is caused by excessive ejection force and insufficient cooling; increasing ejector pin area and extending cooling time are key
¿Le ha resultado útil?
0 personas encontraron esto útil
¡Gracias por sus comentarios!