Extrusion & Post
12 مشاهدة
CEF vacuum section material spitting
ظاهرة المشكلة
The CEF extrusion vacuum section spits material and the vent hole is blocked
تحليل الأسباب
The CEF melt viscosity is low and overflows in the vacuum section; the vacuum section temperature is high and the viscosity is lower, aggravating the spitting; the vent hole design is improper
الحل
1) Reduce the vacuum section temperature by 5-10°C to increase the viscosity; 2) Add a baffle above the vent hole to prevent spitting; 3) Increase the screw speed to accelerate pushing and reduce residence time
الخلاصة الأساسية
Material spitting is caused by low melt viscosity; reducing temperature and adding a baffle are the key
هل كان هذا مفيدًا؟
0 شخص وجدوا هذا مفيدًا
شكرًا لك على ملاحظاتك!