Extrusion & Post
13 visualizações
CEF vacuum section material spitting
Fenómeno do problema
The CEF extrusion vacuum section spits material and the vent hole is blocked
Análise das causas
The CEF melt viscosity is low and overflows in the vacuum section; the vacuum section temperature is high and the viscosity is lower, aggravating the spitting; the vent hole design is improper
Solução
1) Reduce the vacuum section temperature by 5-10°C to increase the viscosity; 2) Add a baffle above the vent hole to prevent spitting; 3) Increase the screw speed to accelerate pushing and reduce residence time
Conclusão principal
Material spitting is caused by low melt viscosity; reducing temperature and adding a baffle are the key
Isto foi útil?
0 pessoas acharam isto útil
Obrigado pelo seu comentário!