Injection Molding
5 مشاهدة
DSTDP injection severe flash
ظاهرة المشكلة
DSTDP injection molded product parting line flash 0.05-0.1mm wide >2mm, requiring secondary trimming
تحليل الأسباب
Injection pressure too high >80MPa, melt overflows from the parting line; clamping force insufficient; mold parting line fitting gap >0.02mm
الحل
1) Reduce injection pressure to 60-70MPa; 2) increase clamping force or use a larger tonnage injection machine; 3) mold fitting gap <0.02mm; 4) increase melt viscosity to reduce mold penetration tendency
الخلاصة الأساسية
Flash is caused by high-pressure injection and mold gap; reducing pressure and improving mold fitting are key
هل كان هذا مفيدًا؟
0 شخص وجدوا هذا مفيدًا
شكرًا لك على ملاحظاتك!