Molds & Tooling
6 مشاهدة
POE internal shrinkage voids
ظاهرة المشكلة
POE thick-wall product center shrinkage voids, diameter 0.5-2mm
تحليل الأسباب
Thick-wall area interior shrinks after cooling but the surface has solidified, cannot be refilled; holding time insufficient, gate freezes too early
الحل
1) Extend holding time until the gate fully freezes; 2) Increase gate size to delay freezing; 3) Product design to reduce wall thickness difference
الخلاصة الأساسية
Shrinkage voids are caused by thick-wall shrinkage and insufficient holding; extending holding is key
هل كان هذا مفيدًا؟
0 شخص وجدوا هذا مفيدًا
شكرًا لك على ملاحظاتك!