Extrusion & Post
6 مشاهدة
Metallocene linear low density polyethylene film gel particles/gel granules
ظاهرة المشكلة
Transparent or translucent granular gel particles are visible in the film, affecting film appearance and transparency.
Gel particles are insufficiently plasticized resin or crosslinked gel, especially obvious in transparent films.
تحليل الأسباب
（1） The high molecular weight fraction in the raw material is not fully plasticized\
（2） Extrusion temperature too low\
（3） Insufficient screw mixing effect\
（4） The raw material contains crosslinked gel\
（5） The filter screen mesh count is insufficient
الحل
（1） Increase extrusion temperature to the higher value within the 190-260°C range\
（2） Optimize screw design, add mixing elements\
（3） Select high-quality raw material with low gel content\
（4） Increase the filter screen mesh count to 80-120 mesh\
（5） Regularly clean the screw and die to prevent carbide formation
الخلاصة الأساسية
Gel particles are caused by insufficient plasticization or raw material quality problems, and need to be solved from temperature control and raw material quality.
هل كان هذا مفيدًا؟
0 شخص وجدوا هذا مفيدًا
شكرًا لك على ملاحظاتك!