Injection Molding
6 مشاهدة
PETG injection molded part shrinkage rate too large
ظاهرة المشكلة
The shrinkage rate of PETG injection molded products exceeds 0.5%, and the dimensions deviate from the mold design.
تحليل الأسباب
Holding pressure and holding time insufficient, feeding inadequate, mold temperature high with large cooling shrinkage, processing temperature high with large specific volume.
الحل
Increase holding pressure (60-70% of injection pressure) and extend holding time; appropriately lower the mold temperature to 20-40°C; control melt temperature at 230-250°C.
الخلاصة الأساسية
PETG is an amorphous material, and the shrinkage rate is mainly controlled by holding pressure and cooling.
هل كان هذا مفيدًا؟
0 شخص وجدوا هذا مفيدًا
شكرًا لك على ملاحظاتك!