Material Drying
2 Aufrufe
PMMA Bubbles Three Routes
Problembeschreibung
Bubbles in PMMA products appear repeatedly and remain after drying
Ursachenanalyse
Bubbles have three routes of causes: moisture, degraded monomer, and entrapped air; treating only one route cannot cure the root; during on-site troubleshooting, verify item by item according to this mechanism, and avoid blindly adjusting the machine based only on experience
Lösung
Identify by air shots: for water bubbles check drying, for degradation bubbles check temperature and residence, for entrapped air bubbles check back pressure and venting; after adjustment, take samples continuously to verify the effect, and resume mass production only after confirming stability
Wichtigste Erkenntnis
Bubbles are systematically troubleshot by the three routes of causes; after confirming effectiveness, solidify the parameters and practices into the work instruction to prevent recurrence; include this case in the defect archive as a reference for troubleshooting similar problems in the future
War das hilfreich?
0 Personen fanden dies hilfreich
Vielen Dank für Ihr Feedback!